WB-M1W2 v.3 firmware changelog
Overview
Device firmware can be updated over Modbus; see the instructions.
This page lists changes since the beginning of 2022. Earlier changes are in Firmware Changelog.
Changelog
4.36.0 (13.08.2026)
- Added DS18B20 temperature correction registers.
- ERRMODBUS012: Fixed possible interruption of Fast Modbus event transmission.
4.35.3 (01.07.2026)
- Improved Fast Modbus arbitration timing stability.
- Fixed Modbus issues:
- ERRMODBUS008: Unexpected behaviour with long request frames
- ERRMODBUS009: Unexpected behaviour when reading near address 0xFFFF in continuous-reading mode
- ERRMODBUS010: Incorrect request validation and handling of invalid requests
- ERRMODBUS011: Incorrect handling of invalid Fast Modbus event-configuration requests
4.35.2 (29.05.2026)
- Fixed event loss when two devices on the same bus transmit events simultaneously.
4.35.1 (28.04.2026)
- Added FlashFS diagnostic service registers
- Optimised stack usage when requesting many registers
4.35.0 (23.03.2026)
- Added support for multiple sensors on each channel
- Improved reliability of saving device state at power loss
- Optimised filesystem operation
- Optimised power-loss handling
4.34.0 (24.12.2025)
- Added stack and RAM monitoring service registers
- Added a service register for the last MCU reset cause
- Added a firmware update counter service register
- Improved MCU supply voltage measurement accuracy on new devices
- Added device batch number registers
4.33.6 (30.04.2025)
- Added a factory-reset register
- Fixed loss of Modbus response under very frequent requests (observed on WB-MAP12E)
- Reduced the Git information area to 25 registers (50 characters)
- Fixed unexpected behaviour when invalid values are written to some registers ERRMODBUS003.
4.33.5 (11.11.2024)
- Added parity checking for received Modbus data ERRMODBUS006
4.33.4 (12.08.2024)
- Fixed the strong pull-up remaining enabled after an input mode change ERRM1W2004
4.33.3 (26.06.2024)
- Changed the WB-M1W2 v.3 device model string
4.33.2 (21.05.2024)
- WB-M1W2 v.3 support
4.33.1 (13.05.2024)
4.33.0 (03.04.2024)
4.32.3 (29.03.2024)
4.32.2 (11.12.2023)
4.32.1 (11.09.2023)
4.32.0 (15.08.2023)
4.29.1 — 4.30.0 and 4.31.0 (testing)
4.29.0 (03.03.2023)
4.28.0 — 4.28.1
4.27.0 (21.02.2023)
4.24.0 — 4.26.0
4.23.1 (05.12.2022)
4.23.0 (14.11.2022)
4.18.10 — 4.22.1+wb1
4.18.9 (30.06.2022)
4.18.6 — 4.18.8
4.18.4 (25.02.2022)
4.18.2 — 4.18.3
4.18.1 (31.01.2022)
4.17.7 — 4.18.0
4.17.6 (26.01.2022)
4.17.3 — 4.17.5